Search results
Mar 6, 2013 · 03-06-2013 12:03 AM. A secondary ACS server receives all the system configurations from the primary server except that you need to configure the following on each secondary server: •License—Install a unique base license for each of the ACS secondary servers in the deployment. •New local certificates—You can either configure the local ...
Oct 4, 2002 · Scenario: Currently have a ACS (3.02) for Win2K, we recently purchased another server (faster) to act as a secondary AAA server. Question: 1) Once the initial replication occurs between the old server (primary) to the new server (secondary), are there any specific steps to make the secondary primary...
Dec 19, 2011 · ACS primary/ secondary config. ngo duyen. Level 1. Options. 12-18-2011 07:46 PM - edited 03-10-2019 06:38 PM. we have 4 ACS in the system: +) In HQ, we have 2 ACS: 1 primary and 1 secondary ACS. +) In Branch office, we have 2 secondary ACS. I suppose Primary fail, could one of secondary ACS automatic become primary so all other ACSs can ...
Aug 31, 2013 · In ACS 5.2, any configuration changes made in the primary instance are immediately replicated to the secondary instance. Only the configuration changes made since the last replication are propagated to the secondary instance. ACS 4.x did not provide incremental replication, only full replication, and there was service downtime for replication.
Aug 6, 2014 · We were having Two ACS(primary and secondary) in our network. secondary server was EOL. Hence we are replacing it with new ACS. Primary ACS is having configuration for TACACS authentication and radius authentication for wireless users. We just replicated this with new ACS. Moreover we had a requirement of 802.1x auth for wired users.
Mar 11, 2010 · I curretly have two ACS servers. The primary server is running version 3.3.3 while the secondary is running 4.2 (recently updated) . The problem I am seeing is when both the primary and secondary are up and running, my users are unable to access any of the tacacs authenticated devices. The really strange thing I am seeing is that we have one ...
Apr 17, 2011 · Say i have a pair of ACS 5.2 and configured for primary and secondary setup. and the log collector is the primary ACS. All network devices are configured to use primary acs 1st for authentication, when primary acs fails it will use secondary acs.
Dec 5, 2015 · 2) If the primary ACS is disconnected then it will not work as a primary. As far as it is concerned its still the secondary of the primary acs which went down. You will not be able to make most changes without going to deployment options and changing to either Local Mode or Promote to Primary.
Oct 31, 2011 · Go to ACS > System Administration > Configuration > Local Server Certificates. Choose Bind CA Signed Certificate, and click Next. Click Browse, and locate the saved certificate. Choose the ACS certificate that was issued by the CA server, and click Open. Also, check the Protocol box for EAP, and click Finish.
Apr 13, 2016 · Options. 04-15-2016 11:18 AM. Hi Jennifer, The manual failover refers to the management/configuration portion of the ACS deployment. In a deployment, changes and management is done only through the primary node which in return pushes the changes to the rest of the nodes in the deployment. So, if the primary node fails then you have to manually ...
